intake problem

[chevy boy II]

i tried putting an edlebrock performer intake on my monte motor yesterday and i got all bolt holes to line up but the middle ones. there at a different angle and seem to pull the intake apart so both sides wont go in only one or none. any ways i can fix this or any other solutions u might have would be great...

[STL2SLO]

What heads and what part # intake do you have? Sounds like throttle body heads with an intake for standard heads.

[camaro1]

yup, i would say you got the wrong intake for those heads,, i have seen people just drill out the center holes a bit and use a washer on the bolt, but if you want it to be correct you will need the correct intake

[BLUE66]

What they said. You have TBI heads. Either fix will work,... if it was mine I'd buy a new intake.

[Slow Ride]

I'll be doing the modification method in a few weeks with my Pontiac. I have TBI heads and a vintage Edelbrock intake. If you go that route contact me.

[superjeep]

You can just get a peice of small steel for the bolt to go threw and cut the correct angle on the bottom so it makes the bolt go straight in.